Datalogic Heron HD3130 Product Reference Manual page 232

References
ACK NAK Timeout Value
This option specifies the amount of time the scanner waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout.
To set this value:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 200 (setting is in 200ms increments). Pad the
3. Go to
4. Scan the bar code: SELECT ACK NAK TIMEOUT VALUE SETTING.
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 5. ACK NAK Timeout Value Setting Examples
STEP ACTION
1 Desired Setting
2 Divide by 200
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK NAK TIMEOUT VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
222
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
page 30 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
200ms
01
'0' and '1'
1,000ms (1 sec.) 5200ms (5.2 sec.)
05 26
'0' and '5' '2' and '6'
Appendix D, Keypad, that
15,000ms (15 sec.)
75
'7' and '5'
Heron™ HD3130