Interface Settings; Configuring Other Features; Software Version Transmission - Datalogic Heron HD3130 Product Reference Manual

Interface Settings

The scanner is typically factory-configured with a set of default features stan-
dard to the interface type you ordered. See
Global Interface Features, starting on page 19
interface types. If your installation requires you to further customize your scan-
ner, you can select other options through use of the instructions and program-
ming bar codes available in the appropriate section for your interface.
• RS-232 ONLY Interface, starting on page 21
• RS-232/USB-COM Interfaces, starting on page 25
• Keyboard Interface, starting on page 35
• USB-OEM Interface, starting on page 47

Configuring Other Features

If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Configuration Using Bar Codes
ning, speaker and LED indicators and other such universal settings.
Reading Parameters
speaker and LED indicators and other universal settings.
Symbologies
gies). These settings allow you to enable/disable symbologies, set label
lengths, require check digit, etc.

Software Version Transmission

The software version of the device can be transmitted over the RS-232, Key-
board and USB interfaces by scanning the following label.
Product Reference Guide
Reading Parameters include programming for scanning,
:
Includes options concerning the bar code label types (symbolo-
:
RevA
Customizing Configuration Settings
"Interface Selection"
provides settings configurable by all
General Features includes programming for scan-
:
Transmit Software Version
on page 11.
15