Tera Gear TER 25K BTU PRO Manual page 9

Step 6
a) Align the holes on body hinge (P) with the holes on the grill body, then screw a
bolt (II), along with a heat insulation washer (LL) into the pre‐drilled hole, and
then seal with a flat washer (KK), a lock washer(JJ) and a wing nut (MM). Tighten
by hand until secure.
b) Align the holes on grill body with the holes on the upper frame, then screw a bolt
(AA), along with a lock washer (DD) and a flat washer (EE) into each pre‐drilled
hole. Tighten by hand until secure.
c) Tighten all bolts by screwdriver until secure.
Step 8
a) Align the holes on the heat insulation panel (AD) with the holes on the lid (T).
b) Insert the pre‐assembled bolt in lid handle (U) with a heat resistant washer (NN) through
the holes on lid (T) and the heat insulation panel (AD), then seal with a flat washer (EE), a
lock washer (DD) and a bolt (AA).
c) Tighten all bolts by hand until secure.
Step 10
a) Align the holes on the right handle (AG) with the hole on the
right side shelf (V), then screw a bolt (AA), a flat washer (EE)
and a lock washer (DD) into each pre‐drilled hole. Tighten by
hand until secure.
b) Loosen the four pre‐installed bolts on the right upper frame (J)
and allow 1/4 bolt's length to extend from right upper frame.
c) Align the holes on the right side shelf (V) with the bolts
extended from the right upper frame. Push down the right side
shelf until it locks into place.
d) Repeat the procedure for the assembly of left side shelf (W).
e) Tighten all bolts by screwdriver until secure.
Step 7
a) Put the burner (R) inside the grill body. Make certain the valve nozzle is inserted
into the burner venturi tube properly and completely.
b) Align the holes on heat insulation panel (AE) with the holes under the bottom of
grill body.
c) Screw a bolt (BB), along with a lock washer (DD) and a flat washer (GG) through
the heat insulation panel, the bottom of grill body and into the burner. Tighten
by hand until secure.
d) Connect the ignition wire with the igniter.
e) Tighten all bolts by screwdriver until secure.
f) Hook the grease cup (S) under the grill body.
Step 9
a) Put the lid upon the grill body.
b) Align the holes on the lid hinge with the holes on the grill
body hinge, then insert the pin (PP) into the hinge hole.
c) Insert a hair pin (OO) into the hole on each end of the pins to fasten the lid and grill body.
- 9 -