Shaft Seal - JLG 600SJ Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
18. Cover shaft splines with an installation sleeve. Install
a new shaft seal (27) with the cup side facing the
motor. Press seal into housing until it bottoms out.
Press evenly to avoid binding and damaging the
seal. Install seal support washer (28) and snap ring
(29).
29
28
27

27. Shaft Seal

28. Seal Support Washer
29. Snap Ring
Figure 3-36. Shaft Seal
3-32
19. Install remaining plugs and fittings to the housing.
Refer to the drawing below for wrench sizes and
installation torques.
5/16in
63 ft.lbs.
(85 Nm)
Figure 3-37. Plugs and Fittings Installation
– JLG Lift –
1/4 in
5/16 in
33 ft.lbs.
63 ft.lbs.
(45 Nm)
(85 Nm)
1/4 in
33 ft.lbs.
(45 Nm)
9/16 in
125 ft.lbs.
(170 Nm)
3 mm
1.5 to 2.5 ft.lbs.
(2.03 to 3.39 Nm)
3121202