Cylinder Kit Assembly - JLG 600SJ Service And Maintenance Manual

block. Using a press, compress the block spring
enough to expose the retaining ring groove. Wind
the spiral retaining ring (7) into the groove in the cyl-
inder block.
11
12
10
9
8
4
5
6
7
4. Block Spring Washer
5. Block Spring
6. Outer Washer
7. Spiral Retaining Ring
8. Retaining Ring
Figure 3-29. Cylinder Kit Assembly
4. Turn the block over and install the retaining ring (8),
hold-down pins (9), and ball guide (10) to the cylin-
der block.
5. Install the pistons (11) to the slipper retainer (12).
Install the piston/retainer assembly into the cylinder
block. Ensure the concave surface of the retainer
seats on the ball guide. If you're reusing the pistons,
install them to the original block bores. Lubricate the
pistons, slippers, retainer, and ball guide before
assembly. Set the cylinder kit aside on a clean sur-
face until needed.
3121202
9. Holddown Pins
10. Ball Guide
11. Piston
12. Slipper Retainer
– JLG Lift –
SECTION 3 - CHASSIS & TURNTABLE
6. Install the journal bearings (13) into the housing
seats. Use assembly grease to keep the bearings
seated during assembly. Ensure the locating nubs
drop into the cavities in the seats. If you're reusing
the bearings, install them in the original location and
orientation. Lubricate the journal bearings.
14
13
13. Journal Bearings
14. Swash Plate
Figure 3-30. Swash Plate and Journal Bearing
7. Install the swashplate (14) into the housing. Tilt the
swashplate and guide the servo lever ball into its
socket in the servo piston rod. Ensure the swash-
plate seats into the journal bearings and moves
freely. Lubricate the running surface of the swash-
plate.
13
3-29