Spectrum24 Ndk For Dos; Installing The Sdk On The Development Pc; Installing The Sdk And Ndk - Symbol PDT 7200 Series Product Reference Manual

PDT 7200 Series Product Reference Guide

Spectrum24 NDK for DOS

The NDK provides the driver, utilities, sample code and documentation necessary to
interface to the Spectrum24 LAN.
The NDK also provides components of the Novell NetWare and LAN Workplace stacks for
use with the PDT 7240. To obtain the full set of components and documentation, contact
Novell.

Installing the SDK on the Development PC

The SDK and NDKs for DOS are installed through Windows. Both use a common directory,
C:\SYMSDK\SDK7000, by default unless you change it. Install the SDK first, then the
NDK(s).

Installing the SDK and NDK

1. Insert the CD in the CD drive on the development PC.
2. From the Start menu, choose Run.
3. In the open box, type:
Note: To ensure the best operation of the SDK and NDK, do not change
the base path set up in the installation.
4. Follow the installation prompts.
5. Repeat the process for the NDK, if required.
Once installation of the development kits is complete, change to the C:\SYMSDK\SDK7000
directory and check for the directories shown in
(Spectrum24 NDK).
2-4
and press ENTER.
<drive>:SETUP
Figure 2-1 (SDK) and Figure 2-2