Restarting After Download Fails; Exiting Ipl - Symbol PDT 7200 Series Product Reference Manual

PDT 7200 Series Product Reference Guide
Error
Verify Failed:
Lost Connection
Cradle Error
To exit and restart IPL, hold the reset button for 12 seconds (or whatever value was set in
Setup).

Restarting after Download Fails

If the download fails, exit IPL by rebooting the terminal.
If possible, determine what caused the download to fail. If a communications failure
occurred, check all the cables between the terminal and the host to ensure they are secure.
If the hex file is too large to fit in the terminal's Flash disk, reset the hex file's size (refer to
Defining Script Properties

Exiting IPL

To exit IPL, cold boot the terminal (hold the reset switch for 15 seconds, or whatever value
was set in Setup). The terminal should boot to an application or to a login screen.
7-22
Table 7-2. IPL Errors
Explanation
This error is caused when the image has been written to
flash, but cannot be read back correctly. It only applies to
critical sections of the flash, and will prevent an exit from
IPL as a critical section of the flash is damaged. If this
error occurs, the terminal needs maintenance. Contact
Symbol Support for help.
This error displays when the terminal is removed from the
cradle during an IPL session. The terminal should be
replaced in the cradle when the host is no longer
transmitting an image, and the image should be resent to
the terminal that lost the connection. Disconnecting the
serial cable does not generate this error, and attempting
to reconnect the cable will result in an Image Corrupt
error.
This error indicates that corrupted data is being
continually received from the cradle. The most probable
cause of the error is an obstruction on the IRDA window
on the terminal or the cradle. If cleaning the windows fails
to correct the problem, then the terminal requires service.
Contact Symbol Support for help.
on page 7-6) and rebuild the image.