Installing The Print Drum (Cylinder) - Riso 590 User Manual

Installing the Print Drum (Cylinder)

1
Place the Print Drum (Cylinder) on
the Rail.
Align the mark on the Print Drum (Cylinder)
with the mark on the guide, and place the Print
Drum (Cylinder) horizontally onto the rail.
Note:
• If the Print Drum (Cylinder) was manually
rotated, be sure to turn it back so that
marks align, after it is placed on the rail.
2
Return the Print Drum (Cylinder) to
its original position.
Push the Print Drum (Cylinder) in as far as it will
go, and then close the Front Cover.
Important!:
• Do not grasp the Print Drum (Cylinder) Handle
when pushing in the Print Drum (Cylinder).
Tip:
Changing the Drum (Cylinder) Type
When you install a different type of Print Drum
(Cylinder), the Confirm Drum (Cylinder) Type
screen appears.
Ready to Make Master
F17
Basic
!!The Print Drum Type
has been Changed!!
Select the Current
Print Drum Type
and
1)
Select the type corresponding to the installed
Print Drum (Cylinder).
2)
Touch [OK].
The Print Drum (Cylinder) type is confirmed
and printing is enabled.
Important!:
• You will not be able to print until the Print
Drum (Cylinder) type is confirmed.
• If you install a non-approved Color Drum
(Cylinder), the message "Wrong-Type Print
Drum (Cylinder) Installed Replace with
Correct Type" is displayed. Install a Color
Drum (Cylinder) specifically approved for
use with this machine.
Replacing the Print Drum (Cylinder) (Color (colour) Change)
Replacing Consumables
Selections Functions Admin.
A3 Drum A4-R Drum
OK
P .1/3
211