2.3 Installation Procedures
2.3.1 Connecting the Power Cord
The panel PC can be powered through an DC outlet (12 ~ 30 V). Be sure to handle
the power cords by holding the plug ends only. Follow these procedures in order:
1.
Connect the female end of the power cord to the DC inlet of the panel PC.
2.
Connect the 3-pin male plug of the power cord to an electrical outlet.
2.3.2 Connecting the Keyboard and Mouse
Connect the mouse and keyboard to the I/O section of PPC. If using a serial mouse
and the panel PC has a touchscreen, it is possible to connect the mouse to any COM
port.
2.3.3 Switching on the Power
Switch on the power switch, which is located inside the bottom side cover.
Figure 2.6 Connecting the Power Cord
9
PPC-3100 User Manual