Installation Procedures; Hdd Installation; Declaration Of Conformity - Advantech MIC-1810 Startup Manual

DAQ Specifications (Cont.)
Counter
Counter chip N/A
Channels 2 channels (independent)
Resolution 32 bits
Compatibility TTL level
Internal 20 MHz or external clock (10 MHz max.),
Base Clock
selectable via software
Input Frequency Max. 10 MHz
Low
Clock Input
High
Low
Gate Input
High
Low
Counter Output
High
Frequency
Measurement
Pulse Width
Error in
Measurement
Advanced
Functions
Pulse Output
PWM Output

Installation Procedures

HDD Installation

1. Unscrew the 4 screws and remove the rear cover.
2. Unscrew the 4 screws affixing the SSD to the rear
cover.
3. Replace the SDD with an HDD.
4. Affix the HDD to the rear cover using the 4 screws.
5. Reconnect the SATA and power cables and replace
the rear cover. Secure in place using the 4 screws.
0.8 V max.
2.0 V min.
0.8 V max.
2.0 V min.
0.8 V max. @+15mA
2.0 V min. @-15mA
0.1% when the input signal
frequency is ≥ 40 KHz
0.1% when the input signal
frequency is ≤ 40 KHz
Within 2% when the output
frequency is > 1 MHz
Within 2% when the output
frequency is > 1 MHz
Installation Procedures (Cont.)
Table Mount Installation
MIC-1810 can be integrated with a table mount for easy
operation. To prevent the system from overheating, the side
of the system with the heat sink must be facing upward.
1. Unscrew the 4 screws affixing the rear cover in place.
2. Align the screw holes of the rear cover with the screw
holes of the table mount. Secure the system to the rear
cover and table mount using the 4 screws.

Declaration of Conformity

This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. The device must not cause harmful interference.
2. The device must accept any interference received,
including interference that may cause undesired
operation
MIC-1810 Startup Manual 3