Installation Procedures; Connecting The Power Cord - Advantech POC-W181 User Manual

Note! Equipotential terminals need a link to hospital ground/earth system
before system boot to protect operator and system.
2.2

Installation Procedures

2.2.1

Connecting the Power Cord

The POC-W181 can only be powered by DC power adapter SINPRO Model no#
HPU100-107. Be sure to always handle the power cords by holding the plug ends
only.
Follow these procedures in order:
1. Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2-7.)
2. Connect the female end of the power cord to the DC power adapter.
3. Connect the 3-pin male plug of the power cord to an electrical outlet.
Figure 2.6 Connecting the Power Cord
11 POC-W181 User Manual