Table of Contents
Advertisement
1.
Resetting the safety thermostats, circuit breakers, overload protectors, or fuse replacements unless warranted
conditions are the cause.
2.
All problems due to operation at voltages other than specified on equipment nameplates conversion to correct
voltage must be the customer's responsibility.
3.
All problems due to electrical connections not made in accordance with electrical code requirements and wiring
diagrams supplied with the equipment.
4.
Calibration of heat controls after the first sixty (60) days on original components. Replacement of items subject
to normal wear to include such items as knobs, light bulbs, baskets, grids, mechanical timers and
thermocouples. Normal maintenance functions including lubrication, adjustments of airflow. thermostats, door
mechanisms, micro-switches, burners and pilot burners and replacement of fuses and indicating lights are not
covered by warranty.
5.
All frypots welded in the field.
6.
Deterioration of aluminum vessels due to insertion of food product or use of abrasive cleaners is not covered by
warranty.
7.
Full use, care, and maintenance instructions are supplied with each machine. Those miscellaneous
adjustments noted are customer responsibility. Proper attention will prolong the life of the machine.
8.
Travel mileage is limited to sixty (60) miles from an Authorized Service Agency or one of its sub-service
agencies.
9.
All labor shall be performed during regular working hours. Overtime premium will be charged to the buyer.
10. All genuine Wells replacement parts are warranted for ninety (90) days from date of purchase on non-warranty
equipment. This parts warranty is limited only to replacements of the defective part. Any use of non-genuine
Wells parts completely voids any warranty.
11.
Installation, labor, and job check-outs are not considered warranty.
WELLS MANUFACTURING COMPANY
SERVICE POLICY AND PROCEDURE GUIDE
ADDITIONAL WARRANTY EXCLUSIONS
page 14
Advertisement
Table of Contents
