Configure I/O Menu - Oce Arizona T220UV User Manual

Océ | User Interface

Configure I/O Menu

2.3.3
The Arizona T220UV printer can accept print job data through two ports, Centronics
paralled and low-voltage differential (LVD) SCSI-2 communication ports. The serial
port can be used to log information. They are built into the printer.
The Active menu allows you to select the type of port - Parallel or SCSI.
Parallel Port
The printer uses a standard Centronics-type parallel data cable to allow access for
service and diagnostic purposes. It is also used for transfering the two special prints:
Menu Tree and Table Grid (see Appendix A).
LVD-SCSI-2 Port Configuration
Océ Display Graphics Systems recommends that you use the Adaptec 29160 68-
pin LVD-SCSI-2 card in the computer that connects to the T220UVprinter.
The printer ships with a standard 32 foot (10 meter) 68-pin SCSI-2 data cable. It
uses the ultra SCSI settings under this menu to support/enhance the transfer speed
of your computer platform when printing to the Arizona T220UV printer.
Note:
If you have any error messages on the computer or printer display pertaining to the
SCSI port, or if print jobs are not transferred to the Print Queue, check that the
SCSSI settings are exactly as indicated in these steps:
2-46
Figure 8 Configure IO Menu
NEVER connect or disconnect SCSI cables with the printer powered
On. Disconnecting powered connections can damage a PC or make the
printer hard drive unusable.
1. Press the MENU button until you see CONFIGURE I/O, then press
ACCEPT
2. Press the + key if you see CONFIGURE I/O active: parallel.
™
3010102780-B