Periodic Inspection - TOHATSU M 6B Owner's Manual

ENOM01106-1

2. Periodic Inspection

It is important to inspect and maintain your outboard motor regularly. Make sure to per-
form each service at interval specified in the chart below. Maintenance intervals are
determined by the number of hours outboard motor has been used or number of
months, whichever comes first.
Item
Carburetor *1
Fuel filter
Fuel System
Piping
Fuel tank
Spark plugs
Ignition
Ignition timing
*1
Starter
motor *1
Starting System
Battery
Starter rope
Propeller
Lower Unit Gear oil
Water
pump *1
Bolt and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-1
Note
It is highly recommended that your outboard motor to go through complete inspection at 300
hours of use.
Servicing Interval
10 hours or 50 hours or
1 month 3 months
INSPECTION AND MAINTENANCE
Every 100
Action
hours or 6
months
Strip, clean and adjust.
Adjust idling.
Check and clean or Replace
if necessary.
Check and Replace if
necessary.
Clean.
Check gaps. Remove
carbon deposits or Replace
if necessary.
Adjust timing.
Check for salt deposits and
battery cable condition.
Check Installation, fluid
quantity, gravity.
Check for wear or damage.
Check for bend blades,
damage, wear.
Change or replenish-oil and
check for water leaks.
Check for wear or damage.
Retighten.
Apply and pump in grease.
Check for corrosion.
Check for corrosion and
deformation.
51
Remarks
0.9-1.0 mm
(0.035-0.039 in)
10
Replace impeller
every 12 months.
Replace.