Periodic Inspection - TOHATSU MFS 6BZ Owner's Manual

ENOM00555-1

2. Periodic Inspection

It is important to inspect and maintain your outboard motor regularly. Make sure to per-
form each service at interval specified in the chart below. Maintenance intervals are
determined by the number of hours outboard motor has been used or number of
months, whichever comes first.
Description
*1
Carburetor
Fuel filter
Fuel System
Piping/Hoses
Fuel tank
Ignition Spark plug
Starting Sys-
Starter rope
tem
Engine oil
Valve Clearance
*1
Engine
Timing Belt
Compression
*1
pressure
Anode
*1
Thermostat
Propeller
Gear oil
Lower Unit Anode
Water strainer
Water pump
*1
impeller
Bolts and Nuts
Throttle Wire
Sliding and Rotating Parts.
Greasing Point
*1: Have this handled by your dealer.
Inspection intervals
First 20 Every 50 Every 100
hours of 1 hours of 3 hours of 6
month months months
Replace Replace
*1
Replace Replace
INSPECTION AND MAINTENANCE
Every 200
Inspection procedure
hours of 1
year
Dismantle, clean, and adjust.
Check and replace if necessary.
Check and replace if necessary.
Check leakage
Clean and eliminate water from the
tank
Check gaps.
Remove carbon deposits or replace if
nessesary.
Check for wear or chafing
Replace
Check and adjust.
Check and Replace if necessary.
Check
Cleck for corrosion and deformation
Check and replace if necessary
Check for bent blades, damage, wear.
Replace orreplenish-oil and check for
Replace water contamination.
Check and clean.
Check for wear or damage.
Check for wear or damage.
Retighten
Check and adjustment
Check and apply grease
65
Remarks
Replace entire
fuel filter
Gap: 0.80-0.9mm
(0.031-0.035 in)
Approx.800ml
(27 fl.oz)
IN : 0.13-0.17mm
(0.0051-0.0067 in)
EX : 0.18-0.22mm
(0.0071-0.0087 in)
10
Approx. 320ml
(10.8 fl.oz)