Periodic Inspection - TOHATSU M 2.5A 2 Owner's Manual

44
INSPECTION AND MAINTENANCE
ENOM01106-1

2. Periodic Inspection

It is important to inspect and maintain your outboard motor regularly. Make sure to per-
form each service at interval specified in the chart below. Maintenance intervals are
determined by the number of hours outboard motor has been used or number of
months, whichever comes first.
Item
Carburetor *1
Fuel filter
Fuel System
Piping/Hose
Fuel tank
Ignition Spark plugs
Starting
Starter rope
System
Propeller
Shear pin &
Split pin
Lower Unit
Gear oil
Water pump *1
10
Bolt and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-1
Note
It is highly recommended that your outboard motor to go through complete inspection at 300
hours of use.
Servicing Interval
10 hours 50 hours Every 100
or or hours or
1 month 3 months 6 months
Action
Clean, and adjust.
Check and clean or Replace.
Check and Replace.
Clean.
Check gaps. Remove carbon
deposits or Replace.
Check for wear or chafting.
Check for bent blades, damage,
wear.
Check and Replace.
Replace or Fill gear oil and check
for water leaks.
Check for wear or damage.
Retighten.
Apply and pump in grease.
Check for corrosion.
Check for corrosion and
deformation.
Remarks
0.9–1.0 mm
(0.035–0.039 in)
180 mL (6.1 fl.oz.)
: 3.5B2
90ml (3.0 fl.oz.) :
2.5A2/3.5A2