Fujitsu ScanSnap N1800 Operator's Manual page 447

When checking the network connection status by a Ping test, the following results are
possible.
Follow each action described below.
"Ping statistics" shows "Lost=0 (0% loss)".
■ Details
Network connection is working properly.
"Ping statistics" shows "Lost=4 (100% loss)".
■ Details
There is no response from the Ping target.
■ Action
The specified Ping target might not be correct. Check that the Ping target IP address, host
name or FQDN is correct.
The network transmission mode may differ from the connection target. In
Network Operating Status" (page
Negotiation" to a fixed mode.
If the Ping target is correct and the network transmission method is appropriate, refer to
"Failure to Connect to a Server Using Its IP Address" (page 451)
"Ping statistics" shows "Lost=N (1 to 99% loss)".
■ Details
Communication with the Ping target is not stable.
■ Action
There may be a quality problem with the LAN cable. Replace the LAN cable and try again.
The network transmission mode may differ from the connection target. In
Network Operating Status" (page
Negotiation" to a fixed mode.
Hardware error.
■ Details
A hardware problem might have caused a communication channel error. For example, the LAN
cable may have become disconnected during the Ping test.
■ Action
Check the status of the LAN cable and try again.
121), change [Link Speed/Duplex Mode] from "Auto-
121), change the [Link Speed/Duplex Mode] from "Auto-
447
"4.8.7 Checking the
for further solutions.
"4.8.7 Checking the