Restoring The System Settings - Fujitsu ScanSnap N1800 Operator's Manual

■ Restoring the System Settings

Restore the system settings.
The system settings can be restored in the following ways.
Return the system settings backup file to the same scanner
Import the system settings backed up from another scanner to the current scanner
1. Select [Monitoring & Management]
Settings File].
The [System Settings File] window appears.
2. Select the backup file of the system settings to be restored.
Press the [Browse] button to select a file.
3. Perform either of the following steps.
To return the system settings backup file to the same scanner, select [Restore
in the same scanner].
To import the system settings backed up from another scanner to the current
scanner, select [Import from another scanner].
4. Press the [Restore] button.
A confirmation message appears.
5. Press the [Yes] button.
The system settings are restored. After the system settings are restored, the
scanner is restarted.
During system settings restoration, do not press and hold down the power
button for longer than 4 seconds.
It may cause the scanner to function abnormally.
The network interface connection will be lost when the scanner is restarted to
complete the restoration of the system settings. To continue with other
settings, wait a short time for the scanner to restart, then login to the network
interface again.
As the network interface connection to the scanner requires the IP address or
scanner name, if this is changed by the restoration of the system settings (i.e.
if the backed up IP address or scanner name is different to the pre-restoration
IP address or scanner name), the new IP address or scanner name will be
needed. If not known, the current state of these settings can always be
checked by physically logging in to the scanner via the LCD touch panel
interface.
[Data Management]
183
[System