Hitch Coupler Adjustment Check; Hitch Coupler Adjustment - DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual

Pull
1/16"
Movement
Figure 70
Lock Nut
Ball Clamp
Figure 71
30.00 COMMERCIAL DR
60
Locking
Trigger
Ball
Spring
®
RAPID-FEED™ CHIPPER
Hi tch Coupler Adjustment Check
1. Place the proper size ball in the socket of the
coupler and close the latch assembly (Figure 70).
Verify that th
its detent.
2. Pull on the b
ball from the
1/16" in the
adjustment. Follow the proper adjustment
procedure in the following steps.

Hitch Coupler Adjustment

1. With the proper size ball in the socket of the hitch
coupler, close the latch of the coupler completely
(Figure 71). Verify that the locking trigger is properly
engaged in its detent.
2. Tighten the lock nut on the underside of the coupler
until the spring between the nut and the clamp is fully
compressed. Then back off the lock nut 1/2 turn or
just enough that the latch is able to clamp and
unclamp from the ball.
e locking trigger is properly engaged in
all and/or coupler, trying to remove the
socket. If the ball moves more than
coupler's socket, the clamp requires