Attaching The Chipper Hopper; Check The Tire Pressure - DR 10 HP CHIPPER Safety & Operating Instructions Manual

Attaching the Chipper Hopper

Tool Needed:
•
(2) 1/2" Wrench or Socket
Tip: Insert a towel or large rag into the opening to keep the Bolts from falling into the Chipper.
1. Attach the Chipper Hopper to the machine using four (4) 5/16"-18 x 3/4" Carriage Bolts, four (4)
5/16" Flat Washers and four (4) 5/16"-18 Nylon Lock Nuts.
NOTE: Be sure to insert the bolts from the inside of the Chipper Hopper so that the threads are sticking out
(Figure 1).
2. Install a Flat Washer, then a Lock Nut on each bolt. Initially install the Bolts and Nuts finger tight
and then tighten the Nuts one (1) turn using two (2) 1/2" wrenches (Figure 1). Check to see that
the Hopper is centered on the Inlet Chute and then tighten the Nuts securely.
3. If you used a towel or rag in the Chipper opening, remove it now.
Access Cover
Chipper Left Side Panel
BE SURE TO FILL THE ENGINE WITH OIL AND GAS BEFORE USE
OIL IN THE CRANKCASE, THE ENGINE WILL BE DAMAGED BEYOND REPAIR AND WILL NOT BE
COVERED UNDER THE WARRANTY. SEE THE NEXT PAGE FOR OIL AND FUEL FILL.

Check the Tire Pressure

There should be 30 psi in each tire.
Bolt (4)
Nut (4)
Washer (4)
Inlet Chute
Figure 1
.
CALL TOLL FREE 1-800-DR-OWNER
Chipper Hopper
IF YOU START THE ENGINE WITHOUT
13