Operation; Maintenance - DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual

180°
Locking
Pin
Figure 47
Lower
Discharge
Deflector
Figure 48
30.00 COMMERCIAL DR
52

OPERATION

Adjusting the Extended Top-Discharge Chute Discharg
Direction:
Extended Top-
Discharge Chut e
NOTE:
Discharge
180˚ that spans the front and both sides of the Chipper. The
Ring
different hole settings at 18˚ increments that you can use
Hitch
Clip
Adjusting the Deflector Direction:
Higher
Discharge

MAINTENANCE

Deflector
Handle
Tools and Supplies Needed:
Lubricating the Extended Top-Discharge Chute:
®
RAPID-FEED™ CHIPPER
1. Pull the Hitch Clip and remove the Locking Pin (
47).
2. Rotate the Extended Top-Discharge Chute to the
direction desired.
The Extended Top-Discharge Chute has a range of motion of
3. Line up the Locking Pin hole to the closest hole setting
in the Discharge Ring.
4. Install the Locking Pin and secure it with the Hitch
Clip.
1. Grab the Deflector Handle and rotate the Deflector to
the desired discharge position (Figure 48).
•
All Purpose Grease
1. Pull the Hitch Clip and remove the Locking Pin from
the Discharge Ring (Figure 47).
2. Apply some all-purpose grease in each hole of the
Discharge Ring and Center Ring as you rotate the
Chute.
3. Rotate the Extended Top-Discharge Chute for the full
180˚ of rotation for a few times to spread the grease
inside the Discharge Ring.
4. Reposition the Extended Top-Discharge Chute to the
desired angle and insert the Locking Pin and Hitch
Clip.
e
Figure
re are 11
.