Installation - DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual

Hitch
Clip
Figure 52
Hitch C lip
and Pin
Figure 53
Collar
Set Screw
Jack
Stands
Figure 54
30.00 COMMERCIAL DR
54
INSTALLATIO
Tools and Supplies Needed:
Standard
Tow Hitch
Pin
Instal
Bolt and
Locknut
Roa d Towing
Tow Hi tch
Bolt and
Lockn ut
Install
NOTE
Tow Hitch
the Chipper for the next procedure. The Tow Bar must be in the
Horizo
in the
Frame
Wheel and
Spacer (behind
wheel)
®
RAPID-FEED™ CHIPPER
N
•
Wire Cutter/Stripper
•
Cable Ties (provided)
•
Two 3/4" Wrenches
•
Two 9/16" Wrenches
•
Two 1/2" Wrenches
•
10" Adjustab
•
Electrical Tape
•
Jack Stands or Blocks
•
Jack
•
5/32" Allen Wrench
•
Needle Nose Pliers
•
Hammer
ling the Tow Hitch:
1. Insert a jack-stand or blocks at the front of the Chipper
to lift the Standard Tow H
2. Remove the Bolt and Loc
Standard Tow Hitch with two 3/4" wrenches (Figure
52).
3. Remove the Hitch Clip and Pin and remove the
Standard Tow Hitch.
4. Position the Road-Towing Tow Hitch and secure with
th e P n and Hitch Clip (Fig i
5. Install the Bolt and Locknut into the Fr
Hitch with two 3/4" wrenches.
ing the Fenders and Axle Assembly:
: It is recommended that the Ball Hitch on the Road-Towin
be hooked up to the Ball on your tow vehicle to stabil
nta position to hitch to the vehicle (see "Towing" procedures l
foll wing section for Tow Bar adjustments). o
1. Insert jack Stands or Blocks
the Frame or hook the Ball Hitch onto the Ball of the
tow vehicle.
2. Jack u p the rear of the Chipper and insert Jack Stands
under the rear corners of the Frame to raise the
Chipper wheels off the ground (Figure 54). The
lowermost part of frame must be at least 10" from the
ground for the Wheel Assembly to fit under.
le Wrench
itch off the ground.
knut from the Frame and
ure 53).
ame and Tow
under the front corners of
g
ize