To Free A Jammed Flywheel - DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual

To Free a Jammed Flywheel

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,
REMOVE SPARK PLUG WIRES, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5
MINUTES BEFORE MOVING OR WORKING ON THE CHIPPER.
Tools Needed:
•
Two 1
Disas semble:
1. Disconnect the battery at the negative terminal.
2. Remove any material left in the Chipper Hopper.
NEVER PRY AGAINST THE SCROLL WELDMENT WHEN REMOVING THE DEFLECTOR OR DISCHARGE
CHUTE, OR AT ANY OTHER TIME. THIS WILL CAUSE DAMAGE TO THE MACHINE.
3. Remove the two Bolts and Locknuts that secure th
with two 1/2" wrenches and then remove the Discharge Chute (
4. Check to see if the Discharge Chute or Discharge openin
5. With a wooden stick, loosen and remove any materi
the Flywheel turns freely with the stick.
Reassemble:
1. Position the Discharge Chute onto the Chipper Basic Assembly and secure with two Bolts and
Locknuts using two 1/2" wrenches.
2. Reconnect the battery negative terminal cable, the spark plug wires and start the Chipper engine;
allowing t he remaining material in the Chipping Chamber to discharge.
3. If the Chipping Chamber doesn't clear and the flywheel is still jammed, repeat above process.
NOTE: Be certain the Chipping Chamber is clear before
Hopper.
/2" Wrenches
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER
Figure 20
e Dis charge Chute to the Chipper Basic Assembly
Figure 20).
g is clogged. If it is, clear it with a branch.
al left in the Chipping Chamber and make sure
trying to process more material into the Chipper
Discharge
Chute
Scroll
Weldment
Bolts and
Locknuts
27