DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual page 62

Figure 64
Wire Harness
Cable
Ties
Figure 65
Ground
Wire
Trailer
Hitch Bolt
Figure 66
30.00 COMMERCIAL DR
58
Light
Bracket
Bolt and
L ocknut
Cab le Tie
Excess Wire
to Tow B ar
NOTE: We recommend that you wrap the Harness wires together
with e
Harness Connector end and going ba
either side of the Frame
®
RAPID-FEED™ CHIPPER
7. Attach both Light Brackets to the Frame with Bolts a
Locknuts with two 1/2" wrenches (Figure 64).
8. Secure the Wires under the Frame with Cable Ties at
the four places shown (Figure 65).
9. Pull the excess wire to the front of the Chipper.
10. Strip 1" of insulation from the end of the White
(Ground) Wire.
11. Loosen a Trailer Hitch Bolt, wrap the White (Ground)
Wire around the Bolt, and then re-tighten with two
3/4" wrenches (Figure 66).
12. Roll up the extra wire and wire tie it to the Tow Bar.
lectrical tape about every twelve inches starting at the W
.
ck to where the wires go to
nd
ire