Starting The Engine - DR 30.00 COMMERCIAL RAPID-FEED CHIPPER Safety & Operating Instructions Manual

Choke
Control
Lever
"CHOKE"
Figure 16
"Run"
Throttle
Control
"Idle"
Lever
Figure 17
Off
Key
Switch
Figure 18
30.00 COMMERCIAL DR
24

Starting the Engine

"RUN"
Run
Start
®
RAPID-FEED™ CHIPPER
1. Ensure that the Fuel Shut-Off Valve is in the "ON"
position (Figure 14).
2. Pull the Choke Control Lever to the "CHOKE" position
(Figure 16) (leave in the RUN position if the engine is
already warm).
3. Ensure that the Throttle Control Lever is in the "IDLE"
position (Figure 17).
4. Insert the Key and turn it to the "START" position until
the engine starts, then release (Figure 18). The Key
will return back to the "ON" position and the engine
will continue to run.
5. As the engine warms up, slowly adjust the Choke to
the "Run" position. Wait until the engine runs
smoothly before each Choke adjustment. For
chipping, operate the engine with the Throttle in the
"RUN" position with the Choke pushed in to the
"RUN" position.