Section Iii - Operation; Before Starting - DR TLC18-CHP Operating & Assembly Instruction Manual

BEFORE STARTING ENGINE, ALWAYS CHECK OIL LEVEL!
Refer to the engine owner's manual for further details
regarding OPERATION AND MAINTENANCE OF the engine.
NOTE: ENGINE IS SHIPPED WITHOUT OIL! FILL CRANKCASE WITH OIL
BEFORE STARTING ENGINE. BE VERY CAREFUL NOT TO ALLOW
DIRT TO ENTER THE ENGINE WHEN CHECKING OR ADDING OIL OR
FUEL.
NOTE: IF YOU START THE ENGINE WITHOUT OIL, THE ENGINE WILL BE
DAMAGED BEYOND REPAIR AND WILL NOT BE COVERED UNDER
WARRANTY.

BEFORE STARTING:

Oil Capacity:
Fuel Capacity:
OIL
• Use a high quality detergent oil classified "For Service SF, SG, SH, SJ" or higher.
• Do not use special additives.
• Choose a viscosity according to the following table.
* CAUTION: Air cooled engines run hotter than automotive engines. The use of non-synthetic
multi-viscosity oils (5W-30, 10W-30, etc.) in temperatures above 40 deg. F (4 deg. C) will result
in higher than normal oil consumption. When using a multi-viscosity oil, check oil level more
frequently.
** CAUTION: SAE 30 oil, if used below 40 deg. F (4 deg. C), will result in hard starting and
possible engine bore damage due to inadequate lubrication.

SECTION III - OPERATION

Oil and Gas Fill-Up
1 ½ quarts (48 ounces)
9 quarts
15