D-Link xStack DES-6500 User Manual page 112

Source MAC
Destination MAC
802.1p (0-7)
Ethernet Type
Port
To view the settings of a previously correctly configured rule, click
screen:
To configure the Access Rule for Packet Content Mask, open the Access Profile Table and click Modify for a Packet
Content Mask entry. This will open the following screen:
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Address - Enter a MAC Address mask for the destination MAC
address.
Enter a value from 0-7 to specify that the access profile will apply only to packets with
this 802.1p priority value.
Specifies that the access profile will apply only to packets with this hexadecimal
802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type
value may be set in the form: hex 0x0-0xffff, which means the user may choose any
combination of letters and numbers ranging from a-f and from 0-9999.
The Access Rule may be configured on a per-port basis by entering the port number
of the switch in the switch stack into this field. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3 - 2:4 specifies all of the ports between switch 1,
port 3 and switch 2, port 4 − in numerical order. Entering all will denote all ports on the
Switch.
Figure 6- 64. Access Rule Display window (Ethernet)
in the Access Rule Table to view the following
97