D-Link xStack DES-6500 User Manual page 71

The Static Multicast Forwarding Settings page displays all of the entries made into the Switch's static multicast
forwarding table. Click the Add button to open the Setup Static Multicast Forwarding Table, as shown below:
The following parameters can be set:
Parameter
Unit
VID
Multicast MAC
Address
Port
Click Apply to implement the changes made. To delete an entry in the Static Multicast Forwarding Table, click the
corresponding under the Delete heading. Click the
Multicast Forwarding Settings window.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 29. Setup Static Multicast Forwarding Table
Description
Choose the Switch ID number of the Switch in the switch stack to be modified.
The VLAN ID of the VLAN to which the corresponding MAC address belongs.
The MAC address of the static source of multicast packets. This must be a multicast
MAC address.
Allows the selection of ports that will be members of the static multicast group. The
options are:
None - No restrictions on the port dynamically joining the multicast group. When None
is chosen, the port will not be a member of the Static Multicast Group.
Egress - The port is a static member of the multicast group.
Show All Multicast Forwarding Entries
56
link to return to the Static