D-Link xStack DES-6500 User Manual page 242

The following fields can be set:
Parameter
Time Interval [1s]
Record Number [200]
Crc Error
UnderSize
OverSize
Fragment
Jabber
Drop
Show/Hide
Clear
View Table
View Line Chart
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 7- 27. Rx Error Analysis window (table)
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select number of times the Switch will be polled between 20 and 200. The default
value is 200.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
The number of packets detected that are less than the minimum permitted packets
size of 64 bytes and have a good CRC. Undersize packets usually indicate collision
fragments, a normal network occurrence.
Counts packets received that were longer than 1518 octets, or if a VLAN frame is
1522 octets, and less than the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to
1522.
The number of packets less than 64 bytes with either bad framing or an invalid CRC.
These are normally the result of collisions.
The number of packets with lengths more than the MAX_PKT_LEN bytes. Internally,
MAX_PKT_LEN is equal to 1522.
The number of packets that are dropped by this port since the last Switch reboot.
Check whether or not to display Crc Error, Under Size, Over Size, Fragment, Jabber,
and Drop errors.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
227