D-Link xStack DES-6500 User Manual page 175

Configure each IP interface individually using the OSPF Interface Settings - Edit menu. Click the Apply button when
settings have been entered. The new configuration appears listed in the OSPF Interface Settings table. To return to the
OSPF Interface Settings table, click the
OSPF interface settings are described below. Some OSPF interface settings require previously configured OSPF settings.
Read the descriptions below for details.
Parameter
Interface Name
IP Address
Network Medium
Type
Area ID
Router Priority
Hello Interval
Dead Interval
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 136. OSPF Interface Settings - Edit window
Show All OSPF Interface Entries
Description
Displays the of an IP interface previously configured on the Switch.
Displays the IP address of the interface and its current status (Link Up / Link Down)
A read only field describing the type of network medium in use. This field will only read
Broadcast due to OSPF configurations permanently set in the Switch.
Allows the entry of an OSPF Area ID configured above.
Allows the entry of a number between 0 and 255 representing the OSPF priority of the
selected area. If a Router Priority of 0 is selected, the Switch cannot be elected as the
Designated Router for the network.
Allows the specification of the interval between the transmission of OSPF Hello
packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello
Interval, Dead Interval, Authorization Type, and Authorization Key should be the
same for all routers on the same network.
Allows the specification of the length of time between the receipt of Hello packets from
a neighbor router before the selected area declares that router down. An interval
between 1 and 65535 seconds can be specified. The Dead Interval must be evenly
divisible by the Hello Interval.
link.
160