D-Link xStack DES-6500 User Manual page 108

To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously
created rule, click the corresponding
Configure the following Access Rule Configuration settings for IP:
Parameter
Profile ID
Mode
Access ID
Type
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 59. Access Rule Table window – IP
button.
Figure 6- 60. Access Rule Configuration window (IP)
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 65535.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet
•
header.
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
IPv6 instructs the Switch to examine the IPv6 part of each packet header.
•
93