Olivetti FK-502 Service Manual page 142

Field Service Ver. 7.0 Jan. 2009
• The error in the Txx/Rxx system may be caused under the effect of line noise, etc. even
in usual operating condition.
• If the error arises often, output the activity report, fax setting list, protocol trace list,
parameter list, address book list, group address list and program list and obtain detailed
information on the error status, conditions which may cause the error, etc. from the user
and contact the support center.
Code No. Category
T00 Sending
T01 Sending
T02 Sending
T03 Sending
T04 Not used
T05 Sending
T06 Sending
T07 Not used
T08 Sending
T09 Sending
T10 Not used
T11 Sending
T12 Sending
T13 Sending
T14 Not used
T15 Not used
T16 Not used
T17 Not used
T18 Sending
T19 Not used
T20 Not used
T21 Not used
T22 Not used
Y104784-2
Contents of Error
T1 timeout. no response obtained
from the machine on the other end
of the line. (35 second)
T1 over after the mode has been
changed (35 seconds)
DCN reception in DIS waiting
Unexpected command reception in
DIS waiting
FIF not matching with the remote
station (remote station without the
function).
DCN reception in CFR/FTT waiting
Training failure at 2400bps
No response to DCS
DCN reception while waiting for
post message responses
Unexpected command reception
while waiting for post message
responses
No response while waiting for post
message responses
No reception ability in a remote sta-
tion
Service Manual
9. TROUBLESHOOTING
How to correct
Check that the address number is
correct.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The line may be in trouble. Check
the line noise.
The line may be disabled because
the user on the remote station dis-
connected it.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
135