Leak Testing - Outback THG2302P-3 Operating Instructions Manual

11
PROCEED TO THE NEXT PAGE FOR INSTRUCTIONS ON OPERATION AND
ALL JOINTS AND CONNECTIONS MUST NOW BE LEAK TESTED BEFORE USING THE
Leak test annually, and whenever the gas bottle is removed or replaced.

LEAK TESTING

Always perform a leak test in a well-ventilated area.
Step 1 - Confirm all control knobs are in the off position.
Step 2 - Detach the barbecue control panel located across the front of the barbecue body by
pulling off the control knobs and removing the control panel retaining screws.
Step 3 - Turn the gas on / open the gas control valve on the gas bottle or regulator.
Step 4 - Check for leaks by brushing a solution of ½ water and ½ liquid detergent / soap over
all the gas system joints, including all valve connections, hose connections, and regulator
connections.
Step 5 - NEVER USE AN OPEN FLAME to test for leaks at any time.
Step 6 - If bubbles form over any of the joints there is a leak
•
Turn off the gas supply at the gas bottle
•
Retighten all joints
•
Repeat test
•
If bubbles form again do not use the barbecue and contact your local Outback distributor for
assistance.
Always wipe the mixed solution (½ water and ½ liquid detergent / soap) from all joints and
connections after leak testing.
Leak Test Diagram
ASSEMBLY IS NOW COMPLETE.
MAINTENANCE
BARBECUE.
10