Polycom SoundPoint IP 200W Provisioning And Configuration Manual page 60

Provisioning and Configuration Guide SoundPoint IP 200W
Name
Handset Default Primary Line Type - The primary line for eight handsets can be configured. The parameter
name for the primary line on handset 1 is shown.
USER_PRIMARY_LINE
_PP1
Handset Default VoIP Line - Eight handsets can be mapped to their appropriate registration. The parameter
name for handset 1 is shown.
USER_VOIP_LINE_PP
1
Emergency Primary Line
EMERGENCY_PRIMA
RY_PORT
Scheduled Firmware Updates
FWU_POLLING_ENAB
LE
FWU_POLLING_MODE
FWU_POLLING_PERIO
D
FWU_POLLING_TIME_
HH
FWU_POLLING_TIME_
MM
A - 14
Type Size Permitted Values
uint8 1 0 = PSTN
1 = VoIP line
(default)
uint8 1 1 to 8
1 = VoIP line 1
(default)
2 = VoIP line 2
3 = VoIP line 3
4 = VoIP line 4
5 = VoIP line 5
6 = VoIP line 6
7 = VoIP line 7
8 = VoIP line 8
uint8 1 0 to 8
0 = PSTN
1 = VoIP line 1
(default)
...
8 = VoIP line 8
uint8 1 0 = disabled
(default)
1 = enabled
uint8 1 0 = absolute
1 = relative to boot
uint32 1 positive integer,
units in seconds
default is 86400
uint8 1 0 - 23
default is 0
uint8 1 0 - 59
default is 0
Interpretation
Outgoing line selection (green button line).
Default VoIP line selection.
Specifies the line to use when emergency
numbers are detected.
If set to 1, schedule firmware updates.
Polling mode for firmware update.
Period to check for new firmware.
Hour for initiating the firmware update.
Note: Use this configurations parameter
together with FWU_POLLING_TIME_MM.
Minute for initiating the firmware update.
Note: Use this configurations parameter
together with FWU_POLLING_TIME_MM.