5.7
Service Mode 7 (LBP Service Mode)
This test mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameter.
Step
1
Standby
2
Press "FUNCTION" and then "7".
3
Press "MONITOR" four times, then press "
4
Press "7".
5
Press "START" for printer parameter settings.
Press "2" and "START" to get the printer information.
Ex: Enter "START" for printer parameter settings.
6
Press "3" and "START". Then enter the number of pages.
Ex: Enter "50" and "START".
7
Repeat step 5 through 6 to request operation, or press "STOP" to return to
standby.
Sub-Code
1
\//\
2
\//\
\//\
Operation or Unit Condition
Parameter Name
1
Printer Counter
2
LBP Fuser Reset
3
Out of Toner
LBP ROM Version
LBP Print Available
LBP MEMORY CAPACITY
∗
".
Displays and resets the printer and cassette(s) counters.
Clears the LBP fuser error.
Sets the number of pages to print after low toner is detected.
Shows the LBP ROM Version.
Shows the remaining number of allowable printable pages after low
toner has been detected (Counter Only).
Shows the page memory capacity.
223
LCD Display
SEP-12-1999
15:00
SET MODE
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
LP SERVICE MODE (1-2)
1:LBP PARAMETER SET
LBP PARAMETER SET
1.PRINTER COUNTER
LBP PARAMETER SET
3.OUT OF TONER
SEP-12-1999
15:00
Description
00%
(1-6)
00%