Service Mode 9 (System Maintenance) - Panasonic DX-2000 Service Manual

5.9

Service Mode 9 (System Maintenance)

5.9.1 Overview
This Service Mode is used to maintain and/or update the firmware of the machine.
Use the following procedure for System Maintenance.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3
Press "MONITOR" four times, then press "
4 Press "9".
5 Press "START" to update the firmware.
Enter No. or press "
Ex: Enter "2".
6 Press "START" and "SET".
7 After the backup is completed, repeat step 5 through 6
to request an operation.
8 Press "STOP" to return to standby.
No. Maintenance Mode
1 FIRMWARE UPDATE
2 FIRMWARE BACKUP
3 PARAMETER RESTORE
4 PARAMETER BACKUP
PC → FLASH CARD
5
Operation or Unit Condition
∗
".
∨ ∧
" or " " to select the maintenance to be performed.
System Maintenance Table
Updates the firmware in the machine with the Master Firmware Card.
Creates a Backup Card of the machine's firmware.
(A 2 MB or higher Flash Memory Card is required)
Restores the parameters from the Backup Card into the machine.
Creates a Backup Card of the machine's parameters.
(A 1 MB or higher Flash Memory Card is required)
Creates a Master Firmware Card using the Firmware Update Kit.
(A 2 MB or higher Flash Memory Card is required)
Description
229
LCD Display
SEP-12-1999 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
SYSTEM MAINT. (1-8)
1:FIRMWARE UPDATE
SYSTEM MAINT. (1-8)
2:FIRMWARE BACKUP
FIRMWARE BACKUP
* IN PROGRESS *
SERVICE MODE
ENTER NO. OR
SEP-12-1999 15:00
00%
Rev. 1