Counter Location; Electrical Requirements; Initial Unit Assembly; Pinch Tubes - Cornelius JETSPRAY JS7 Owner's Manual

C L
OUNTER OCATION
The unit must be located with at least 3 inches of space on back and sides of dispenser, to ensure proper
ventilation. Keep space above unit open. Lint or dust collecting on the condenser will result in poor refrigeration.
The counter must be capable of supporting 100 lbs. (45.36 kg).
E R
LECTRICAL EQUIREMENTS
Refer to the nameplate to determine the power requirements before connecting electrical power to the unit. All of
the power cords shall comply with safety requirements outlined in the EC Standards (EN60335-1 1 Clause 24.1) in
countries where CE compliance is required.
The power circuit must have some sort of overload protection, such as a circuit breaker or fuse that meets local and
national electrical codes. Table 1 shows the power requirements for the various types of units.
I U A
NITIAL NIT SSEMBLY

Pinch Tubes

NOTE: Bowl must be installed on unit prior to performing this procedure.
1. Remove the pinch tubes from the plastic bag and wash them with warm water and mild detergent or soap.
2. Before installing the pinch tubes, wet the bowl spout surface and sealing rings on the pinch tube.
3. Push back the handle until it touches the front panel.
4. With the other hand, pick up the pinch tube, as shown in Figure 2. Carefully insert the tube into the bowl
spout opening and through the lower opening of the handle support spout.
5. When the end of the tube passes beyond the bottom of the handle spout, pull the end of the tube to seat
the pinch tube top into the bowl spout seat. Tube should extend approximately 1/4 in. below the spout.
NOTE: Make sure that the tube is free of wrinkles.
6. Release the handle and install the second tube (JT20 or 30 only).
© 2007-2015, Cornelius Inc.
Part No. Model
A8701 JS7
A8711 JS7-W25
Figure 2.
Table 1.
Receptacle Type
115VAC, 60Hz, grounded
230VAC, 50Hz, grounded
- 5 -
JetSpray JS7 Owner's Manual
Pinch
Tube
Publication Number: 18478