Maintenance Procedures; Cleaning The Bowl (Daily); Cleaning The Condensate Drain (Weekly) - Cornelius JETSPRAY JS7 Owner's Manual

MAINTENANCE PROCEDURES

C B
LEANING THE OWL
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify
all power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
1. Turn off power to the unit.
2. Before removing the bowl, turn off the spray switch.
3. Drain any product left in the bowl.
4. Remove the pinch tube by pushing the handle until it stops and pulling up on the pinch tube until it is free
(See Figure 2.), then remove the handle (See Figure 4.). Lift off the bowl, drip trays and covers. Clean
them thoroughly.
5. Clean the unit, as described in the "Cleaning the Dispenser (For First Use)" section.
6. After cleaning, reassemble the unit as described in the "Re-Assembly after Cleaning" section. Replace the
push handle and insert the pinch tube into the bowl.
C C
LEANING THE ONDENSATE
1. To remove the condensation drain, push in on the front panel, just under the drain and pull down with fingers, as
shown in Figure 10.
Condensation Drain
2. To replace the condensate drain, place the drain against the front panel under the drain hole (opening in
side of drain should be toward front panel). Push up until the drain snaps into place (See Figure 11).
© 2007-2015, Cornelius Inc.
(D )
AILY
D (W
RAIN
Figure 10.
Toward
Front Panel
Figure 11.
- 9 -
)
EEKLY
JetSpray JS7 Owner's Manual
Publication Number: 18478