4. Check that the bowl spout gasket is mounted properly to the base assembly, as shown in Figure 6.
5. Slide the bowl over the cooling coil and assemble the bowl to the dispenser. Be careful not to wrinkle the
gasket. If gasket is wrinkled, beverage will leak out of bowl. (See Figure 7.)
6. Replace the push handle and pinch tube.
A. Push the handle assembly straight up through the rectangular hole until the clips snap into place.
(See Figure 8.)
© 2007-2015, Cornelius Inc.
Bowl Gasket
3
5
7
1
8
6
4
Bowl Spout Gasket
Place Bowl
on Top of Unit
2
Figure 5.
Pinch Tube
Figure 6.
Figure 7.
- 7 -
JetSpray JS7 Owner's Manual
Cooling Coil
Publication Number: 18478