Viewing The User Authentication Status Information; Showing The 1X Client Probe Timer Configuration - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 37 Configuration of 802.1X
Command
configure terminal
dot1x auth-address-table address
mac-addr interface interface
end
write
show dot1x auth-address-table
Use the no dot1x auth-address-table address command to delete the specified
authenticable host list. The following example shows the list of the hosts that can be
authenticated.
DGS-3610# show dot1x auth-address-table
interface:g3/1
-----------------------------------
mac addr: 00D0.F800.0001
37.3.4 Viewing the User Authentication
Status Information
The administrator can view the authentication status of the current users of the switch for
easier troubleshooting.
In the privileged mode, you can view the user authentication status information through the
following steps:
Command
show dot1x summary
The following example shows the user authentication status information.
DGS-3610# show dot1x summary
ID MAC
---- ----------- --------- ---- ---------- ------------
1 00d0f8000001 Gi3/1
37.3.5 Showing the 1x Client Probe Timer
Configuration
In the privileged mode, you can view the 1x timer setting through the following steps:
Command
show dot1x probe-timer
The following example shows the 1.1x timer setting:
DGS-3610# show dot1x probe-timer
37-34
Interface VLAN Auth-State Backend-State Port-Status
1 Authenticated IDLE
DGS-3610 Series Configuration Guide
Function
Enter the global configuration mode.
Set the list of the hosts that can be authenticated.
Return to the privileged mode.
Save the configuration.
Show the list of the hosts that can be authenticated.
Function

Viewing the user authentication status information

-----------
Authed
Function
Show the 1X timer setting