Enabling The Bpdu Source Mac Check - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 17 MSTP Configuration
Command
DGS-3610# show running-config
DGS-3610# copy running-config
startup-config
It will enter the privilege mode and configure the TC Guard on the port according to the
following steps
Command
DGS-3610# configure terminal
DGS-3610(config)# interface
Interface-id
DGS-3610(config-if)# spanning-tree
tc-guard
DGS-3610(config-if)# end
DGS-3610# show running-config
DGS-3610# copy running-config
startup-config
17.4.7 Enabling the BPDU source MAC
check
After the BPDU source MAC check is enabled, the switch accepts only the BPDU frames
whose source MAC addresses are the specified MAC, and filters all the received other
BPDU frames.
Enter the interface mode and perform the steps below to configure the BPDU source MAC
check:
Command
DGS-3610# configure terminal
DGS-3610(config)# interface
Interface-id
DGS-3610(config-if)#bpdu
src-mac-check H.H.H
DGS-3610(config-if)# end
DGS-3610# show running-config
17-32
DGS-3610 Series Configuration Guide
Function
Check the configuration entities.
Save the configuration.
Function
Enter the global configuration mode.
Enter the configuration mode of this interface, and the
legal interface includes the physical port and the
Aggregate Link.
Enable the TC Guard of this interface.
Return to the privilege mode.
Check the configuration entities.
Save the configuration.
Function
Enter the global configuration mode.
Enter the configuration mode of this interface, and the
legal interface includes the physical port and the
Aggregate Link.
Enable the BPDU source MAC check
Return to the privilege mode.
Check the configuration entities.