D-Link xStack DGS-3610 Series Configuration Manual page 613

DGS-3610 Series Configuration Guide
Command
DGS-3610(config)# access-list id {deny |
permit} [prot | {[ethernet-type] [cos cos]}] [VID
vid] {src src-wildcard | host src }
{host src-mac-addr | any} {dst dst-wildcard |
host dst | any}{host dst-mac-addr | any}]
[precedence precedence] [tos tos] [ dscp
dscp] [time-range tm-rng-name]
DGS-3610(config)# interface interface
DGS-3610(config-if)# expert access-group id {in |
out }
Method 2: Run the following command in the ACL configuration mode:
Command
DGS-3610(config)# expert access-list
extended {id|name}
DGS-3610(config-exp-nacl)# [sn]{ permit |
deny }[prot | {[ethernet-type] [cos cos]}] [VID
vid] {src src-wildcard | host src | interface
idx}{host src-mac-addr | any} {dst
dst-wildcard | host dst | any}{host
dst-mac-addr | any}][precedence
precedence] [tos tos] [ dscp dscp]
[[time-range tm-rng-name]
DGS-3610(config-exp-nacl)# exit
DGS-3610(config)# interface interface
DGS-3610(config-if)# expert access-group
{id|name} {in|out}
Note
Method 1 only configures the numerical value ACL. Method 2 can
configure names and the numerical value ACL. In a version supporting
priority table entries, method 2 can also specify the priorities of table
entries (the [sn] option in a command).
Chapter 44 Access Control List Configuration
Function
Define an access list. For details about
commands, please see command reference.
Select the interface to which the access list is
applied.
Apply the access list to the specific interface
Function
Enter the access list configuration mode
Add table entries for ACL. For details about
commands, please see command reference.
Exit from the access control list mode and
select the interface to which the access list is
applied.
Apply the access list to the specific interface
44-13