Configuring Aggregate Port; Default Configurations Of Aggregate Port; Configuration Guide For Aggregate Port - D-Link xStack DGS-3610 Series Configuration Manual

DGS-3610 Series Configuration Guide
Figure 7-2 AP traffic balancing
7.2

Configuring Aggregate Port

7.2.1 Default Configurations of Aggregate
Port
The default configurations of AP are shown in the table below.
Attribute
Layer-2 AP interface
Layer-3 AP interface
Traffic balancing
7.2.2 Configuration Guide for Aggregate
Port
The speed rates of the AP member ports must be coherent.
L2 ports can only be added to a L2 AP, and L3 ports can only be added to a L3 AP.
The AP cannot be set with any port security function.
When a port is added to an AP that does not exist, the AP will be created automatically.
Source MAC based traffic
distribution
Aggregate Link
Destination MAC based
traffic distribution
Default value
None
None
Trafficbalancing is distributed according to the source MAC addresses
of the input packets.
The defaut traffic balancing of DGS-3610 series switches is balanced
according to the source MAC address+destination MAC address
input.
Chapter 7 Aggregate Port Configuration
7-3