Enabling Aaa; Disabling Aaa; Subsequent Configuration Steps; Configuring Authentication - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 37 Configuration of 802.1X
For complete descriptions of the commands mentioned in this chapter, see the related
chapters in the Security Configuration Command Reference.
37.5.2

Enabling AAA

It is required to enable AAA first to use the AAA security features.
To enable AAA, execute the following command in the global configuration mode:
Command
DGS-3610(config)# aaa new-model
37.5.3

Disabling AAA

To disable AAA, execute the following command in the global configuration mode:
Command
DGS-3610(config)# no aaa new-model
37.5.4

Subsequent Configuration Steps

After the AAA is enabled, you can configure the other parts related with the selected security
solutions. The following table lists the possible configuration tasks and their description
chapters.
Methods of AAA access control security solution
Configuration task
Configuring Local Login Authentication
Defining AAA Authentication Method List
Applying Method List on Specific Interface or
Line
Configuring Radius Security Protocol
Parameters
Enabling Radius Authorization
If you are using AAA for authentication, see Configuring Authentication.

37.6 Configuring Authentication

ID authentication means a user is authenticated before the use of network resources. In
most cases, the authentication is implemented with the AAA security features. We
recommend the use of AAA.
37-4
DGS-3610 Series Configuration Guide
Function
Enable AAA
Function
Disable AAA
Step Chapter
3 Configuring authentication
3 Configuring authentication
4 Configuring authentication
2 Configuring Radius
5 Configuring authorization