Obtaining Help - D-Link xStack DGS-3610 Series Configuration Manual

DGS-3610 Series Configuration Guide
Command
mode
Interface
configuration
(Interface
configuration
mode)
Config-vlan
(Vlan
configuration
Mode)
1.2

Obtaining Help

You may list the commands supported in each command mode by inputting a question mark
(?) at the prompt. You can also list command keywords beginning with the same character
or parameters of each command. See following table.
Command
Help
abbreviated-command-entry?
abbreviated-command-entry<Tab>
?
Access
Prompt
method
Input the
interface
command to
enter to this DGS-3610
mode in the (config-if)#
global
configuration
mode:
In the global
configuration
DGS-3610
mode, input the
(config-
vlan vlan-id to
vlan)#
access this
mode:
Description
Obtain brief description from the help system in any
command mode.
Obtains a character string of command keywords
beginning with the same.
Example:
DGS-3610# di?
dir disable
Obtains complete keywords of commands.
Example:
DGS-3610# show conf<Tab>
DGS-3610# show configuration
Lists the next keyword associated to the command.
Example:
DGS-3610# show ?
Chapter 1 Command Line Interface Configuration
Exit or access next mode
To return to Privileged EXEC
mode, input end command or
Ctrl+C. To return to Global
configuration mode, input exit
command . You must indicate
to enter to the interface
configuration sub_mode in the
interface command.
To return to Privileged EXEC
mode, input end or Ctrl+C.
To return to Global
configuration mode, enter
exit.
About this
mode
Configure
various
interfaces of the
network
equipment in
this mode.
This mode is to
used for setting
VLAN
parameters.
2-3