D-Link xStack DGS-3610 Series Configuration Manual page 484

Chapter 35 IP Multicast Routing Configuration
Enabling PIM-SM (required)

Configuring the Hello message sending interval (optional)

Configuring PIM-SM neighbor filtering (optional)

Configuring the priority of specified device DR (optional)

Configuring the candidate BSR status (optional)

Configuring static RP (optional)

Configuring candidate RP (optional)

Configuring particular source multicast (optional)

Configuring flood/prune time for the timer (optional)

Configuring the speed limit on the sending of registered packets (optional)

Configuring reachability detection for registered packets (optional)

Configuring the source address of registration packets (optional)

Configuring the RP suppression time (optional)

Configuring the time of the KAT timer (optional)

Switching the last-hop device from shared tree to the shortest path tree (optional)

Switching the last-hop device from shared tree to the shortest path tree in multiple

multicast groups (optional)
Show the status of the PIM-SM (optional)

35.6.22.1 Enabling Multicast Routing
The multicast routing must be enabled before the multicast packets can be transmitted, and
so that enabling the PIM-SM is meaningful.
35.6.22.2 Enabling PIM-SM
The PIM-SM must be enabled on each interface. The device can interact with other devices
for PIM-SM control messages, maintain and update multicast routing tables and forward
multicast packets only after PIM-SM is enabled on the interface.
To configure the PIM-SM on the interface, execute the following command in the interface
mode:
Command
DGS-3610(config-if)# ip pim
sparse-mode
DGS-3610(config-if)# no ip pim
sparse-mode
35-28
DGS-3610 Series Configuration Guide
Function
Enable the PIM-SM protocol on the interface
Disable the PIM-SM protocol on the interface