Table of Contents
Advertisement
Use the PGND cable provided with the switch to connect the grounding strip in the equipment room.
Otherwise, the grounding effect may not be ensured, which easily causes damage to the switch.
Installing a Power Module
The S5810 series provides two power module slots on its rear panel. Hot swappable power module slot
1 is empty when the switch is shipped, and hot swappable power module 2 is installed with a filler panel.
You can select one or two power modules for your switch as needed. For details about optional power
modules, refer to
The installation and removal procedure includes the installation and removal of power modules and
power cords. To prevent damage to the device and personal injury, follow the installation and removal
procedures illustrated in
Figure 3-12 Installation procedure
Install the
Install the
power module
power module
Figure 3-13 Removal procedure
Switch off the
Switch off the
power module
power module
Installing the Power Module
Step1 Wear an ESD-preventive wrist strap, ensure a good skin contact and make sure that the
ESD-preventive wrist strap is properly grounded.
Step2 Take the power module from the package and check that the power module model is as required.
Step3 Face the slot into which the power module is to be inserted.
Step4 Insert the power module with the upside up. Grasp the handle of the module with one hand and hold the
module bottom with the other, and then slide the module slowly along the guide rails into the slot (see
callout 1 in
Figure
Step5 Fasten the captive screw on the power module clockwise with a Philips screwdriver until the power
module is fixed into the chassis (see callout 2 in
Hot Swappable Power Modules
Figure 3-12
and
Connect the
Connect the
power cord
power cord
Disconnect the
Disconnect the
power cord
power cord
3-14).
on page 1-14.
Figure
3-13, respectively.
Switch on the
Switch on the
power module
power module
Remove the
Remove the
power module
power module
Figure
3-14).
3-8
Advertisement
Table of Contents
