H3C S5810-50S Installation Manual page 45

S5810 series

Hide thumbs Also See for S5810-50S:

Table of Contents

PCB Version

Mac Address

Press Ctrl-B to enter Extended Boot menu...5

In normal startup mode, the waiting time here is five seconds. If you press Ctrl + B within five seconds,

the Boot ROM menu is displayed. If you perform no operation or press a key other than Ctrl + B within

five seconds, the system begins to automatically start up and the following information is displayed:

Starting to get the main application file--flash:/s5810 RELEASE.bin!...

..................................................................

The main application file is self-decompressing................................

...............................................................................

Done!

System is starting...

Board checking.....................................LSW158150S

Switch chip selftest......................................OK!

SDRAM fast selftest.................................NOT TEST!

Flash fast selftest.......................................OK!

PHY selftest..............................................OK!

CPLD selftest.............................................OK!

Please check port leds..............................finished!

User interface aux0 is available.

Press ENTER to get started.

The appearance of "Press ENTER to get started" indicates that the automatic startup of the switch is

complete.

Press Enter. The following prompt is displayed:

<H3C>

You can configure the switch now.

To switch to the fast start mode, select 9 from the Boot ROM menu, enter N after the prompt

information is displayed, and then reboot the system.

The H3C series switches provide abundant command views. For detailed descriptions about the

configuration commands and CLI, refer to H3C S5810 Series Ethernet Switches Operation Manual

and H3C S5810 Series Ethernet Switches Command Manual.

: Ver.A

: 00E0FC005810

4-9

Table of Contents

S5810-50s-dc