Table of Contents
Advertisement
3
Installing a Switch
On a mounting screw of the chassis of the H3C series switches, there is a seal labeled with H3C. You
need to keep it intact before asking the agent to maintain the switch. You need to get the permission of
the local agent before you can open the chassis. Otherwise, you will be responsible for irreversible
damages caused by your operations.
The switches in the installation procedures of this chapter are only for illustration sake. For real
appearance of the switch, refer to the actual product.
Installing the Switch into a 19-Inch Rack Using Mounting Brackets
The S5810 series switches can be installed into a 19-inch rack with load-bearing mounting brackets.
Figure 3-1
show how to install an S5810 switch into a 19-inch rack.
Figure 3-1 Install an S5810 into a 19-inch rack
Introduction to Mounting Brackets
The S5810 series switches provides a pair of 1U mounting brackets as shown in
Figure 3-2 Mounting brackets of an S5810
3-1
Figure
3-2.
Advertisement
Table of Contents
