Table of Contents
Advertisement
7)
Restart the switch to make the updated Boot ROM file effective
Press any key to return to the Boot ROM update menu.
Press enter key when ready
1. Update full BootRom
2. Update extended BootRom
3. Update basic BootRom
0. Return to boot menu
Enter your choice(0-3):
Enter 0 to return to the Boot ROM menu, and then enter 0 again. After that, the device is restarted and
the updated Boot ROM file becomes effective.
Loading an application file
To load an application file of the switch, enter 1 in the Boot ROM menu. The system displays the
following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can enter 2 to load the application file.
The procedure of loading an application file is similar to that of upgrading the Boot ROM program. The
difference lies in that the system displays the prompt of loading the application file rather than upgrading
the Boot ROM program.
After loading the application file, the switch displays that you should configure the application attribute,
that is, main, backup, or none. Type a specific attribute to complete loading the application file.
Writing flash..................................................................
................Done!
Please input the file attribute (Main/Backup/None) M
Done!
If an application file with a specific attribute already exists when you set a new file with the attribute, the
attribute of the existing file becomes none after the new file becomes effective.
Loading Software Through CLI
By connecting a terminal to the switch, you can upgrade the Boot ROM program and load application
files of the switch remotely through CLI.
5-17
Advertisement
Table of Contents
